Nice! I hope it’s not too hot when using it. I once made a case that wasn’t able to sustain the temperature.

They need a cloud connection for the setup, but there is a “LAN only mode” (there are still some messages yet). There is also a new X1E (enterprise edition) that is said to be totally offline if needed.

Nice !

I would go with wood filament.

I wanted to know the date of this comic. It was issued in Eightball #5, February 1991.

I just measured it and the overhang behind is half the bed and half the infamous cable. You need around 60cm between the front feet and the wall behind, for the cable not to be torn when the bed is all the way to the back.

The bed goes back and forth. On the back, you need the place since there is the infamous cable that should not be torn. On the front, the bed can go over the void. There is no need for a 70 cm large table, maybe 50cm with overhang.

It’s a mess. I have the A1 with AMS and it takes way more space than I wanted. The coreX with AMS are way more compact.

Edit.
Wide 80cm (with the poop chute on the left and the AMS on the right) Depth 70cm (with all the cables and the bed going back and forth) Height 60cm with the top roll

I would like to get one for our club but I can’t understand the wide variety of prices. $150 ? $500 ? $2000 ? $10000 ? $75000!! ? What’s the cheapest that is not a pain to use ?

What slicer is it ? I will check if it is possible to set no purge at all in BambuStudio - since I have an AMS lite.

It looks feasible with a purge multiplier set to 0. https://forum.bambulab.com/t/setting-an-unbeatable-record-no-flush-at-all/51052/4

I say to people : if you’re interested in 3D printing, you need two hobbies. 3D printing and anything else. The second hobby can be repairing things, a sport (spearfishing for me), board games, electronics, etc.

I started with a 100€ very small 3D printer for years (Tina2) and that was so worth it. Now I have a Bambulab with AMS and it’s night and day.